If your Roborock Dyad Pro or A10 Plus still runs but barely picks up water and debris, the suction fan motor is usually the culprit. Worn bearings and a tired impeller show up first as weak pickup, a higher-pitched whine, or streaks left behind on hard floors. This replacement motor assembly restores the airflow the machine was built with, for a fraction of the cost of a new unit.

Compatibility

• for Roborock Dyad Pro
• for Roborock A10 Plus

Check the model label on your machine before ordering. Fan motors vary between Dyad models and are not interchangeable across series.

Key Features

• Complete suction fan motor assembly, installed as a single unit
• Restores original suction power on both wet and dry cleaning
• Direct-fit replacement matched to the Dyad Pro / A10 Plus housing
• Fixes weak pickup, unusual noise, and poor water recovery

What's in the Box

• 1 x Suction fan motor assembly

Installation Tips

• Unplug the machine and empty both the clean and dirty water tanks first
• Clear hair and residue from the air duct while the motor is out, or the new one will lose airflow again
• Reseat all gaskets and connectors flat, since air leaks cost you suction

Not sure this is the part your machine needs? Send us your model number and we'll confirm the fit before you order.

Disclaimer: This is a replacement part. Brand and model names are used only to indicate compatibility. Not affiliated with or endorsed by Roborock.